Ladder Setups for Manufactured Home and RV Work
Ladder Setups for Manufactured Home and RV Work
A manufactured home is only 13 or 14 feet tall, so a ladder job sounds simple. Then the ground turns out to be sand, the skirt panel is plastic, the roof is a quarter inch of decking over purlins, and a foot in the wrong place goes through.
Why the Roof Is the Risk
A site-built roof has plywood over rafters and an attic to spread a load. A manufactured home has a metal or shingle roof over thin decking on purlins, and an RV has rubber membrane over luan and foam with almost nothing between the walker and the ceiling below.
That means point loads are the enemy. Kneeling on a knee pad and spreading weight across a sheet of plywood is standard practice on both. A worker who steps off a ladder directly onto a purlin bay can go through.
Getting Up There Safely
Set an extension ladder at four to one with the top three feet above the roof edge, and use a standoff so the ladder bears on the eave and the wall instead of pressing into the gutter or the roof edge. A 24 foot ladder covers most single-wides; a 28 foot handles the taller park models.
Our Werner Type IA fiberglass extension ladder starts at $299 and the Louisville Type IA fiberglass ladder starts at $298.74. Fiberglass does not conduct, which matters when the ladder goes up next to a service mast or a park pedestal.
Never climb the awning, the hitch or a stack of blocks. Those are the three most common improvised routes in a mobile home park and all three fail.
Soft Ground and Skirting
Park pads are often gravel, sand or bare dirt, and the skirt panel is cosmetic. Put plywood pads under the ladder feet and set them on undisturbed ground, never on the skirting, a concrete block or the edge of a patio slab.
If the ground is soft after rain, move the ladder rather than dig the feet in deeper. A foot buried four inches in sand is not a foot that will hold when the worker shifts weight.
Re-Leveling and Underbelly Work
Re-leveling a home means working under it: jacks, shims, piers and vapor barrier, usually in 18 to 30 inches of clearance. A step stool and a creeper are the tools, and the ladder is only for getting to the frame and the tie-downs.
Our Type IA fiberglass step stool at $97 fits under the frame and handles the low reach, and a Type IA stepladder starts at $99 for the skirt and utility connections.
Never work under a home that is supported only on jacks. Set the frame on blocks and piers before anyone goes underneath.
RV Roof Reseal and Detail Work
An RV roof sits at 10 to 11 feet and gets resealed every year or two: lap sealant at the vents, around the skylight, along the cap rail. The work is small and repetitive, and the membrane tears if a ladder top or a knee presses on it.
Use a standoff on the ladder, step onto the roof at a seam or a reinforced area, and keep tools in a soft bag rather than a metal tray. A dropped scraper goes through a membrane and a ceiling in one motion.
For the sides, an podium ladder lets a detailer work the windows and the cap rail at a stable height, and the stepladder range covers the lower panels.
Spread the load: Thin decking over purlins needs a plywood sheet, not a knee.
Not on the skirt: Skirting and blocks are not ladder footing.
Park Work Needs a Portable Kit
A mobile home or RV kit is one 24 or 28 foot fiberglass extension ladder with a standoff, a step stool for the underbelly, and a stepladder for the sides. It all fits in a service truck.
Tell us the roof heights and the ground you work on and we will match the ladder.
Everything ships from 5030 Dexham Rd. Ste. 103 in Rowlett, TX, and local crews can pick up the same day. Call 972-331-1090 and we will tell you what is on the floor right now.
Shop Extension Ladders
Fiberglass and aluminum extension ladders in stock in Rowlett.
Shop Extension LaddersRecent Posts
-
Ladder Work at Substations and Switchgear Yards
Ladder Work at Substations and Switchgear Yards A substation is a yard full of equipment that is ei …Nov 17th 2026 -
Ladders and Scaffolds for Waterproofing and Sealant Work
Ladders and Scaffolds for Waterproofing and Sealant Work A waterproofing crew follows a joint. The …Nov 17th 2026 -
Ladders for Commercial Cleaning and High Dusting
Ladders for Commercial Cleaning and High Dusting A commercial cleaning crew covers a building every …Nov 17th 2026