Blog
Ladder Setups for Manufactured Home and RV Work
Ladder Setups for Manufactured Home and RV Work
A manufactured home is only 13 or 14 feet tall, so a ladder job sounds simple. Then the ground turns out to be sand, the skirt panel is plastic, the roof is a quarter inch of decking over purlins, and a foot in the wrong place goes through.
Why the Roof Is the Risk
A site-built roof has plywood over rafters and an attic to spread a load. A manufactured home has a metal or shingle roof over thin decking on purlins, and an RV has rubber membrane ove
…
Nov 17th 2026
Chimney, Flue and Fireplace Work
Chimney, Flue and Fireplace Work
The older neighborhoods in Dallas, from Swiss Avenue to Lakewood to Munger Place, are full of tall masonry chimneys on steep roofs. A chimney sweep or mason working those houses needs roof access that does not damage the shingles and a way to work the stack itself.
Getting to the Roof Without Damaging the Shingles
A ladder laid straight against a gutter crushes it and puts the feet on a surface that gives. A standoff or a walk-through top section spreads the loa
…
Oct 31st 2026
Ladder Safety for Home Inspectors
Ladder Safety for Home Inspectors
A home inspector works alone, on a house nobody has looked at yet, with a camera in one hand and a schedule that does not allow for a second setup. The roof is a ten minute visit and the ladder is the whole day, which makes ladder choice the single biggest safety decision in the trade.
Ten Minutes on the Roof, Six Hours on the Ladder
Most inspection falls happen at the transition, not out on the field: stepping off the top of a ladder onto a roof, or swinging a
…
Oct 20th 2026
Working on Standing Seam Metal Roofs
Working on Standing Seam Metal Roofs
A standing seam roof is a finished surface, not a substrate. Every step lands on the customer's visible product, and every seam is a raised folded edge that was never designed to carry a boot. Crews that treat it like shingle come away with dents they cannot explain and slips they did not expect.
The Seam Is Not a Step
A standing seam is folded metal standing an inch or more above the panel. Standing on it flattens the fold, and a flattened seam is visible f
…
Oct 20th 2026
Holiday Light Installation: Ladders for Roofline Work
Holiday Light Installation: Ladders for Roofline Work
Holiday light work happens in the worst conditions of the year: short days, cold hands, wet lawns, and a roofline the customer will look at every night for six weeks. Most of the risk sits at the ladder rather than up on the roof, and almost all of it is predictable.
How Much Ladder a Two-Story Eave Actually Takes
A two-story DFW house usually carries its eave between 18 and 22 feet, with a gable peak higher than that. Reaching it means the
…
Oct 20th 2026