Ladders and Scaffolds for Waterproofing and Sealant Work

Ladders and Scaffolds for Waterproofing and Sealant Work

A waterproofing crew follows a joint. The caulk line runs along a wall, over a parapet and around a corner, and the work is only efficient if the worker can stay at the joint instead of climbing down and moving a ladder every six feet.

The Work Is One Continuous Joint

Expansion joints, control joints and window perimeters are linear. A sealant tech needs a steady hand at the same height for a long run, with a caulk gun, a tool and a rag within reach.

On a one-story wall that is a Baker unit rolling along the run. On a two or three story wall it is a pump jack plank, or a scaffold built along the elevation. A stepladder handles the first eight feet and nothing above it.

Baker Units Along a Wall

A rolling Baker unit with a deck at four to five feet puts a sealant tech at the joint on a one-story commercial wall, and the unit moves with the work. Our Baker-Perry scaffold unit with casters and a wood deck is $229.

Add the guard rail assembly at $147.70 when the deck is above the first level, and keep the casters clear of fresh caulk and dropped tips. A wheel rolled through a bead of sealant tracks it across the concrete.

Pump Jacks for Tall Walls

A pump jack system carries a plank on poles anchored at the wall top, so a crew can work a 20 to 40 foot elevation without building a full scaffold. It suits sealant and waterproofing because the work is a narrow horizontal band that moves up as the joints are completed.

Our Werner aluminum pump jack is $272, the poles and connectors start at $152 per set, and the rigid support brace at $115 keeps the poles from walking. Add the pump jack safety net at $370 on any elevation over a walkway or a parking area.

Anchor the poles to structure that can take the load, not to a parapet cap or a fascia. A pump jack pulls outward at the top, and a decorative cap will let go long before the jack does.

Parapets, Roof Edges and Deck Coatings

Parapet work is edge work. A worker leaning over a parapet to run a termination bar at the roof edge is one slip from a fall, and a ladder set against the parapet is not a guard rail.

Where a crew works within six feet of a roof edge, a fall protection kit at $89.38 and an anchor plan are the minimum. On a coated deck, keep ladders off the fresh membrane until it has cured and use pads under every foot.

Solvent, Caulk and Ladder Care

Solvent-based cleaners, primer and polyurethane sealant all end up on gloves, rails and rungs. Wipe the rails at the end of the day and check the rungs for a slick film before the next climb.

Store the ladder out of the sun and off the ground. UV and standing water are what kill a fiberglass ladder, not the work itself.

Never stand on a bucket, a five gallon pail or a stack of membrane rolls. The crew already has a ladder; use it.

Move the platform, not the worker: A rolling deck keeps a sealant crew at the joint.

Pads on fresh membrane: Cured coating only, and never a ladder foot on a seam.

Staging for Long Runs

Waterproofing and sealant work wants staging that travels: a Baker unit for one story walls, pump jacks for tall elevations and a harness for the roof edge. Buy the system once and it follows the joint.

Tell us the wall heights and how the top of the wall is built and we will size the system.

Everything ships from 5030 Dexham Rd. Ste. 103 in Rowlett, TX, and local crews can pick up the same day. Call 972-331-1090 and we will tell you what is on the floor right now.

Shop Pump Jacks

Pump jacks, poles, braces and safety nets in stock in Rowlett.

Shop Pump Jacks
Nov 17th 2026 Noah Khomer

Recent Posts